Powermatic 2800 Uživatelský manuál Strana 1

Operating Instructions and Parts Manual 18-inch Variable Speed Drill Press Model 2800 WMH TOOL GROUP 2420 Vantage Drive Elgin, Illinois 60124 P

10Installing Arbor and Chuck 1. Disconnect machine from power source. 2. Thoroughly clean the entire arbor and the inside of the chuck (Figure 9) w

11Improper connection of the equipment-grounding conductor can result in a risk of electric shock. The conductor with insulation having an outer surf

124. The drill press must comply with all local and national codes after the 230 volt plug is installed. 5. The drill press with a 230-volt plug sh

13Table Extensions Loosen the handles (C, Figure 15) and slide the extensions outward, then re-tighten the handles. Changing Spindle Speeds Change

146. Make sure the coil spring cover is pushed back in, then tighten the two hex nuts (D). Do not over tighten. The hex nuts should be tightened aga

15Repeat step 5, if necessary, until the light and marking are aligned. 6. Adjust the other laser in the same manner. Two parallel laser markings sh

16Maintenance Before doing maintenance on the machine, disconnect it from the electrical supply by pulling out the plug or switching off the main sw

17Trouble Probable Cause Remedy Noisy Operation (cont.) Noisy motor. Check motor bearings or for loose motor fan. Wood splinters on the underside. N

18Model 2800 Drill Press

19Parts List: Model 2800 Drill Press Index No. Part No. Description Size Qty 1... PM2800-001 ...Strain Relief...

2Warranty and Service WMH Tool Group, Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Authorized Servi

2057... PM2800-057 ...Rack Ring... 1 58

21117... PM2800-117 ...Bracket... 1 1

22178... TS-152706...Hex Wrench ...5 mm... 1 179...

23Electrical Connections

24Electrical Connections

3Table of Contents Warranty and Service ...

4 Warning 1. Read and understand the entire owners manual before attempting assembly or operation. 2. Read and understand the warnings posted on th

5 21. Give your work undivided attention. Looking around, carrying on a conversation and “horse-play” are careless acts that can result in serious i

6Introduction This manual is provided by WMH Tool Group covering the safe operation and maintenance procedures for a Powermatic Model 2800 Drill Pres

7Unpacking Open shipping container and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not discar

8Assembly Tools required for assembly: Cross-point (Phillips) screwdriver Rubber mallet Wrenches – 17, 18 and 24 mm Set of hex (Allen) wrenches Expo

93. Slide the large handle onto the spindle of the table bracket (Figure 4), and tighten the set screw in the handle with a 3mm hex wrench. Crank th